If grime and oils are involved you must clear away All those to start with with some thing alkaline (Feel degreaser/surfactant (like your purge merchandise) then use acid for mineral scale.

Pool college is a collection of concise, effortless to be aware of article content suitable for the standard pool operator. The posts have been thoroughly published and arranged to take you thru a normal progression of pool care topics.

San Rafael, CA United states of america Jan 27, 2015 Include bookmark #three Do you think you're confident you weren't applying sodium persulfate (not monopersulfate)? This isn't similar to potassium monopersulfate. The focus is likely to generally be different so you must dose by distinctive amounts. Sodium persulfate is often accessible in a more pure sort while potassium monopersulfate is almost always from the triple salt so most products and solutions with it are no more than 43% MPS.

Another thing to remember is usually that pump operate time will not avoid algae, only preserving a suitable chlorine level can do this.

I believe there are actually not that lots of Intelliflo3 pumps linked to IntelliTouch techniques. New pumps are increasingly being mounted with EasyTouch or IntelliCenter programs.

Mdragger88 stated: For decontamination uses you'll be able to Enable the purge water sit right away with slam fc amount. Kinda like soaking a gross pot

and of 31.45% muriatic acid to compensate with the pH boost. To decreased Borate you swap with the drinking water with new water. Note: The pH should be tested and modified as required following increasing the borate level. Temp

Good day , This thread is inactive for over sixty times. New postings Here i will discuss unlikely to get found or responded to by other users. For much better visibility, contemplate Setting up A New Thread.

Any Strategies as checked the jumper, did the black, environmentally friendly an yellow relationship as purple will not be employed for some reason. Address is one such as pump.

I have never worked with the new IntelliFlo3.. But I 'Consider' which you can utilize the application or you'll be able to Command through the RS-485 cable, although not each concurrently.. For a take a look at, I would want to be sure the app just isn't wanting to talk with the pump, when utilizing the com cable.

For those who had been applying persulfate, then it really is an irritant Until silver ions are present through which case it breaks down making impressive sulfate radicals that will promptly oxidize bromide to bromine. Persulfate by alone will not respond with bromide (nor chloride, but it does react with iodide).

He says he has four other pumps executing exactly the same issue and no responses from Pentair. Pentair desires to deliver far more techs out. Who else is acquiring this issue??

Nov seven, 2024 Incorporate bookmark #fourteen effectively a tech arrived out and It's a terrible upper board exactly where the Serial port sits. Poor out of your box! Now focusing on a completely new MasterTemp heater put in that doesn't want to speak at all to my Intellitouch.

My JXI unit does not have a heater bypass although the unit by itself has the aptitude for just one to generally be included. After i experienced a power outage and electrical power was restored the unit came back again on pool edelstahl komplettset the internet and Versaflo bypass valve may possibly have already been activated and since I would not have the valve in the least I used to be getting the mistake code. I Slash electricity and reset and it arrived back on the internet Using the Versaflo deactivated and no challenge considering the fact that.

I'm able to make this happen. The information regarding stunning the pool suggests to get it done as generally as hourly right up until it holds the level right away. That's the shock degree, suitable? In my circumstance 15ppm?